RC8.2 1MM OFFSET INSERT BUSHING -1 DOT BY AVID

pour une meilleur traction en arriere!

By using this 1mm Offset Insert Bushing (1 Dot) in the D plate of the RC8.2 with the hinge-pin hole in the lower position (closet to ground), you are lowering your roll center which will increase rear traction. A common setup trend on the RC8.2 is to run more rear toe by running 2 or even 3 Dot out. By running our offset insert you may run less toe while still maintaining the same level of confidence you had when you ran 4 – 5 degrees. The benefit comes into play with more control of your car in the turn due to less toe angle fighting the inconsistency of the track surface. And even though more rear toe gives more rear bite it does cause the car to initially respond very quickly while entering a turn before the chassis roll has begun which can get you into trouble sometimes.
Features

Each package includes 4 inserts (blue aluminum plate not included).1mm offset lowers the rear inner arm pivot for a lower roll center when used in D-plate (*see table for toe-in).Precision machined delrin with dot indicators as well a “L” and “R” for the 2 and 3 dot inserts.Inserts also fit the #89461 Front B-plate to lower the front roll center to a middle location between the standard RC8B and the RC8.2 low B plate #89481.Fits: RC8.2, RC8.2e, RC8T CE, RC8BWeight: 0.43g (each)